Highlogo

HighLogo microprocessor controls are the convenient solution for monitoring and level-dependent switching of one or two directly starting sewage pumps with or without explosion proof protection. The compact housings (IP44) of the single and duplex units allow space-saving installation inside the building or in an outdoor column outside.
The operating status of the pump station is indicated via the graphic display and an additional LED. The control system can be operated and set intuitively via a multifunction button and a push-button. The multilingual menu can be used to display the operating hours and switch-on cycles of the pump(s), the current consumption, any fault messages and a maintenance reminder. An integrated event memory offers additional diagnostic options. Fault messages and a high-water alarm are reported via the display and an alarm buzzer and can be forwarded via potential-free contacts. In addition, the direct connection of a 230V warning signal is possible.
In the event of a mains failure, a high-water alarm can be signalled by means of an optional 9V rechargeable battery. In addition, it is possible to issue differentiated fault messages via SMS and e-mail using an optional, integrated GSM modem.
HighLogo controls have connection options for digital and analogue level sensors. These can be found in different versions in the accessories section and must be additionally configured. For waste water applications, submersible switch packages are usually used, for wastewater pumps dynamic pressure systems (see also HighLogo LC variants). Furthermore, systems for analogue level detection are available (dynamic pressure sensor module or hydrostatic submersible probe), with which the water level can be read on the display and switching levels can be conveniently set via the control panel of the control unit.