Hebefix Mini | Jung Pumpen
Drainage lifting station

Hebefix Mini

The smallest wastewater lifting station for pre-wall or direct connection

Areas of application: Dirty water and condensation water from cooling
and air-conditioning units.
Also suitable for the disposal of condensate from gas condensing boilers
Made in Germany

  • Ready to connect
  • Quiet
  • Pressure-tight tank
  • Hot water up to 55 °C (short-term 70 °C)
  • For saline solutions up to 15 % salinity
  • For condensate ≥ pH 3,0
  • Wall or floor installation

The drainage lifting station Hebefix Mini is the smallest member of our Hebefix series and can be installed quickly and easily. Thanks to its very compact design, it not only fits into all commercially available pre-wall systems, but also finds its place in a vanity unit or next to a shower. The three inlet options (2 x DN 50, 1 x DN 40) and a flexible pressure outlet in DN32 make it a small all-rounder when only limited space is available.
The Hebefix Mini can be used wherever faecal-free waste water above or below the backpressure level cannot be disposed of in gravity. Hand washbasins, showers, bidets and water softeners for detached and semi-detached houses can be connected. Condensation water from refrigerated counters and air-conditioners, condensate from pellet heating systems and gas condensing boilers as well as waste water from dishwashers in tea kitchens (without meal) and hot water up to 55 °C (temporarily 70 °C) can also be disposed with the Hebefix Mini.
It has a pressure-tight tank, a swing-type check valve and all the necessary devices for floor or wall mounting.
The unit is ready for plug in into to a shock-proof Schuko socket. For installation in bathrooms and showers, the relevant VDE regulations must be observed.
In case of pre-wall installation, a suitable inspection opening, a tank ventilation into the operating room and an alarm system (accessory) must be provided for installation and maintenance work on the system.

Scope of supply

Unit (ABS) incl. pump and swing-type check valve according to EN 12050, ready for plug-in with 2 m cable and safety-plug, PVC fitting, flexible discharge, connecting sleeves, plug-in seals, ventilation insert with activated carbon filter, clamps and fastening material.

Specifications can be changed without notice. Performance subject to ISO 9906 tolerances.

The minimum flow velocity in the pressure piping must be 0.7 m/s according to EN 12056.
This data is represented in the performance curve as a limit of application.

1 results

TypeCode No.
JP48727

Mindig jól informált!

Iratkozzon fel hírlevelünkre


Közvetlen kapcsolat

Jung Pumpen GmbH

hu.jp@pentair.com

Ferenc Besenyei Farkas

Fon: +36 30 346 5605
Magyarországi Közvetlen Kereskedelmi Képviselet, Andrássy út 121
1133 Budapest, Hungary

JUNG PUMPEN GmbH

Industriestraße 4-6
33803 Steinhagen
Germany
Fon +49 5204 17-0
E-Mail info@jung-pumpen.de